Can someone give me some names of custom cuemakers who use 3/8 x10 pin? I'm looking to fit a 314-2 onto something 
3/8 x 10 cuemakers??
- Thread starter 14.1player
- Start date
Dz
Uh...I know Bob at DZcues uses a 3/8x10 pin mostly.He's still reasonably priced too!
14.1player said:Can someone give me some names of custom cuemakers who use 3/8 x10 pin? I'm looking to fit a 314-2 onto something
Uh...I know Bob at DZcues uses a 3/8x10 pin mostly.He's still reasonably priced too!
Bob Frey... http://www.cuesnthings.com/
Kevin Varney
andy gilbert, darrin hill, ronnie powell, judd fuller
joints
Some more for ya'! Kornele, some Josey, Bob Hunter,Gilbert, some Mali, Showcase cues, Olivier, Murrell cues, Mcdermott, Coker cues, Chudy cues, some Buss cues, just to name a few that use or have used this type of joint. Good luck finding what it is you want
Some more for ya'! Kornele, some Josey, Bob Hunter,Gilbert, some Mali, Showcase cues, Olivier, Murrell cues, Mcdermott, Coker cues, Chudy cues, some Buss cues, just to name a few that use or have used this type of joint. Good luck finding what it is you want
GoTulane
Shizzle-rific
Dominiak cues
Bill uses a 3/8 x 10, and his cues are inexpensive to say the least. Less than the predator shaft you own probably. But he uses some nice curly maple and would be a great cue for you to add a predator to. Check out his website:
Dominiakcues.com
Hope this helps.
Michael
Bill uses a 3/8 x 10, and his cues are inexpensive to say the least. Less than the predator shaft you own probably. But he uses some nice curly maple and would be a great cue for you to add a predator to. Check out his website:
Dominiakcues.com
Hope this helps.
Michael
14.1player said:Can someone give me some names of custom cuemakers who use 3/8 x10 pin? I'm looking to fit a 314-2 onto something
Almost any cue maker will use a 3/8-10 pin if requested. I mean ther is not much to it if you building someone a cue anyway!!!
I think the better question is what cue makers will not use a 3/8-10 pin!!
