This old Brunswick came out of a storage room at the assisted living center where I play. I had never seen such a beat-up cue. I felt a challenge to give it a new life.
Fred, the apparent owner, modified the cue so the short steel rod slid forward into 1"+ of compressed foam when shooting. Newspaper was placed around and at the rear of the rod. I unraveled a piece of newspaper and found an ad for a Volvo car dealer in Santa Maria, CA dated 1954. What a mess.
I dug out the foam and newspaper, epoxied a 7" length of half inch rebar and a butt plug cut from a broom handle, installed a new bumper, ferrule, and Elkmaster tip, and wrapped the butt with coarse speckled linen stitchery thread, Three coats of water based varnish, and the cue now weighs 18.2 ounces with a shaft diameter of 11.5 mm. It is straight enough and plays better than I do.
Can anyone tell me how old this cue is? I am guessing it was sold in the US in the early 1950s.
Thank you.
Rick
Fred, the apparent owner, modified the cue so the short steel rod slid forward into 1"+ of compressed foam when shooting. Newspaper was placed around and at the rear of the rod. I unraveled a piece of newspaper and found an ad for a Volvo car dealer in Santa Maria, CA dated 1954. What a mess.
I dug out the foam and newspaper, epoxied a 7" length of half inch rebar and a butt plug cut from a broom handle, installed a new bumper, ferrule, and Elkmaster tip, and wrapped the butt with coarse speckled linen stitchery thread, Three coats of water based varnish, and the cue now weighs 18.2 ounces with a shaft diameter of 11.5 mm. It is straight enough and plays better than I do.
Can anyone tell me how old this cue is? I am guessing it was sold in the US in the early 1950s.
Thank you.
Rick



