Cue coreing

E

EddieBme

AzB Silver Member
Silver Member
I'm considering coring out the butt end of my cue, for weight reduction. The cue is solid wood to the butt cap,( no weight bolt), and weighs about 21oz., so I'd like take out enough wood to make the weight +/- 19oz. The only tools I have to work with is a hand drill. The cue isn't real expensive, but I don't want to mess it up either. Do you think it can be a DIY fix? Any help would be appreciated.
Thanks,
Eddie
 
The fact that you're asking for help suggests that it's not DIY doesn't it ?
Now, can it be done ? Possibly but I doubt with any accuracy. Cheap cue; it better be.
So far you have a cheerleader and a realist. The Unicorn will be along shortly.
 
EddieBme said:
I'm considering coring out the butt end of my cue, for weight reduction. The cue is solid wood to the butt cap,( no weight bolt), and weighs about 21oz., so I'd like take out enough wood to make the weight +/- 19oz. The only tools I have to work with is a hand drill. The cue isn't real expensive, but I don't want to mess it up either. Do you think it can be a DIY fix? Any help would be appreciated.
Thanks,
Eddie
Click to expand...
Sell it and buy a 19oz cue!
 
I my experience.......... you won't even get close to 2 oz weight reduction......... and you will probably ruin the cue.

Kim
 
To know roughly how much weight you can drill out you have to decide first what the wood is you will be drilling out. Then how large is the hole going through the butt plate? That lets you decide how large of bit you can use. Then you have to decide how you are going to drill that hole straight and centered? It will not be easy to do by hand.
Taking it to someone that has a lathe and the long bits is good advice. Just be prepared to live with what will most likely be around a one ounce or maybe a little more than that reduction. Also be aware that it will make your cue more likely to warp in the future.

So I guess I am in the realist camp also.
 
EddieBme said:
I'm considering coring out the butt end of my cue, for weight reduction. The cue is solid wood to the butt cap,( no weight bolt), and weighs about 21oz., so I'd like take out enough wood to make the weight +/- 19oz. The only tools I have to work with is a hand drill. The cue isn't real expensive, but I don't want to mess it up either. Do you think it can be a DIY fix? Any help would be appreciated.
Thanks,
Eddie
Click to expand...

Is this your Palmer?
 
I appreciate all the suggestions, and comments. That's the reason I ask in the forum, there was a lot of information I never would of thought of, well until it would've been to late.
Thanks so much to All.
 
pescadoman said:
I am embarrassed to say I have no idea what you are talking about...
Click to expand...

I want you to drill out a butt in an attempt to lighten it.......... you will see that you don't lighten it any appreciable amount............

I have tried it and I was surprised on how little weight was removed.

kim
 
whammo57 said:
I want you to drill out a butt in an attempt to lighten it.......... you will see that you don't lighten it any appreciable amount............

I have tried it and I was surprised on how little weight was removed.

kim
Click to expand...

I was trying to reinforce what you are saying, not dispute it. I thought knowing that you'd have to cut out half a shaft worth of wood would help him understand easier.
 
You must log in or register to reply here.
Back
Top