Does anyone know what these are called?

jmizzo

AzB Silver Member
Silver Member
waHJMtx.jpg


I lost/wasn't one in one of the spots for this on my Gabriels table. They are threaded with a pass thru to lock in the corner bracket to the side skirts. There are two sizes, I need the smaller one. Is this something a hardware store carries? What would I call them. Sorry for the bad quality.
 
Sorry if this isn't much help but it looks like a type of coupling nut. As to where to get this type I am not sure where to look. I'm sure one of the mechanics on here will be able to direct you.


Good shooting to you,

Kevin
 
waHJMtx.jpg


I lost/wasn't one in one of the spots for this on my Gabriels table. They are threaded with a pass thru to lock in the corner bracket to the side skirts. There are two sizes, I need the smaller one. Is this something a hardware store carries? What would I call them. Sorry for the bad quality.
I think diamond carrys gabriel billiard tables, so maybe they can help you.
 
It is very similar to that, but two holes where a small metal shaft goes through. Then there is a recessed screw that secures the shaft in the nut. Ill try to put better pics up later. Thanks so far for the ideas.




Cross Dowel Nut , type that into google :)

Trent from Toledo
 
waHJMtx.jpg


I lost/wasn't one in one of the spots for this on my Gabriels table. They are threaded with a pass thru to lock in the corner bracket to the side skirts. There are two sizes, I need the smaller one. Is this something a hardware store carries? What would I call them. Sorry for the bad quality.

Check you PM, I have these.
 
If I remember you will need metric nuts. Been a few years since I touched one of those tables..
 
They are sort of like that. They have three holes, two where a smooth rod with a divet on it runs through, and then there is a headless screw that threads in with an allen wrench to secure the post running though it.
 
They are sort of like that. They have three holes, two where a smooth rod with a divet on it runs through, and then there is a headless screw that threads in with an allen wrench to secure the post running though it.


If you need these, I have them original Gabriels.
 
yes absolutely. I need the smaller of the two, the one that goes on the skirts and not the rail. What would be the cost shipped to 56425? Thanks.
 
Hi,

I have them in stock, those inserts are used to pull together the aprons to the 90 degree corner blocks. The larger ones are used to pull together the rails. I also have the nylon inserts and bushings for the corner blocking.

Jay
603 765 6160
 
Back
Top