I need a bucket of popcorn
here’s 3 for you.I need a bucket of popcorn
Dennis VERY SPORTY PLAYER for sure-I’m aware of that.
Point is he’s a player and understands cues
Eric CrispSearing hands down has the best shaft wood.
Eric Crisp Sugar Tree is a very close 2nd
Barry Szam has some great shafts too but those really aren’t available at this point.
Manufactured cues, Mezz shafts are good
That’s been my experience.
Thing is luck plays a part in getting a great shaft. I’ve owned 100’s of them and any brand of cue can have a amazing shaft if you get lucky. Good wood just happens……
I need someI do.
In my opinion… Dennis Searing. I’ll also put Tascarella up there also.Howdy All;
Who, makes the BEST wooden shafts? I realize that the shaft/ferrule/cue tip is the
bit that is where the rubber meets the road so-to-speak. The butt mainly being the
engine that powers the vehicle as it were.
A few years ago there was a lot of talk going on about a certain shaft that one of
the Pros was using Chinakhov (sp?), I think it was. Not sure of the Tourney.
Just had to ask.
hank
Good guy, I should call him.Eric Crisp
Lol! While I make a decent shaft, I was really being a smart ass to very subjective question! I’m so slow that I started a cue over 15 years ago and just finished it up last month!I need some
Do you work for Southwest?I’m so slow that I started a cue over 15 years ago and just finished it up last month!
Lol. I don’t take orders and build just for myself. I did make a cue for a good friend’s birthday but that only took 5 years. It was a gift from his wife.Do you work for Southwest?
What are the chances of ever getting a DS shaft? Zero most likely. Wouldn't get out of the electric chair to give that nit a quarter. Hsu is a good guy for sure. Very responsive to questions/messages. Bob Owen and C. Nitti make fine shafts also. Stand up guys too.In my opinion… Dennis Searing. I’ll also put Tascarella up there also.
Other than that, I steer people toward Richard Hsu.
Probably as close as dukedude getting a DZ shaft..What are the chances of ever getting a DS shaft? Zero most likely. Wouldn't get out of the electric chair to give that nit a quarter. Hsu is a good guy for sure. Very responsive to questions/messages. Bob Owen and C. Nitti make fine shafts also. Stand up guys too.
If people only knew what's inside in some shafts from names mentioned....here’s 3 for you.
I hope you enjoy them, PM me if you need more
Best
Fatboy <———likes popcorn too!!
Good luck getting a Judd. Or a Dayton.Paul Dayton
Mike Gulyassy
Judd
Howdy All;
Who, makes the BEST wooden shafts? I realize that the shaft/ferrule/cue tip is the
bit that is where the rubber meets the road so-to-speak. The butt mainly being the
engine that powers the vehicle as it were.
A few years ago there was a lot of talk going on about a certain shaft that one of
the Pros was using Chinakhov (sp?), I think it was. Not sure of the Tourney.
Just had to ask.
hank